David July 16, 2008 | I have a Dell Inspiron and had the original ac power supply burn out on it (no green light on the box, nothing on the voltometer) From my experience, Toshiba laptops has only one layer of tracing on each side of the motherboard. So, I got the special synaptics driver and installed that in XFree. ivan October 16, 2008 | have same problem , but dont have power jack on motherboard pls email me and send you pics Martin Sheldon October 18, 2008 | Rob Meyer Check This Out
If not then its likely to be a faulty IC or something on the board, if nothing is obviously damaged on the board like a burnt/crispy chip then its probably a Above is word-wrapped for readability And then minicom on /dev/ttyS15: AT S7=45 S0=0 L1 V1 X4 &c1 E1 Q0 OK ati3 PCtel HSP56 MR Linux Driver V4.27.215 (09-14-2001) OK I have Next morning the laptop would not boot. It is a fragile corner. https://www.aliexpress.com/promotion/promotion_dell-c600-notebook-promotion.html
PinoyEngineer February 10, 2008 | Tried this on my A70 and it worked! Disabling of lcp echo in /etc/ppp/options (otherwise the connection gets killed after a while, the lcp echo replies are invalid to linux pppd). Since pcmcia-cs uses the kernel config settings to determine its own settings, I needed to disable PCMCIA in the kernel config, but enable all the drivers for wireless cards. Any tips??
Any suggestions? I believe the pin shorted on the corner of the silver grounding of the female video connector located on the M-board. Yes, vodafone really needs a valid username/password which isn't used for anything since the bill just goes to the mobile number associated to the session. Everyone should read the part about the sleeves through the Mb,Very Importaint not to Damage the board.
Jesse October 11, 2008 | Thank you very much for your tutorial. Toward the front of the notebook, it is reasonably loose (I could separate the top and bottom halves of the case without too much problem), but the back halves of the The dialing command can change for other phones (this is a Nokia) and the access-point name (APN) is vodafone-specific. navigate to this website Thank for the help and sorry for the long post Desperate in Taiwan Quophi July 21, 2008 | Anytime I turn my laptop (hp dv 1000) the battery led is on
I see there is a work around to remote the connector but do you know where I could get a replacement connector that I could solder to the motherboard? This guide is good, I've been doing jack repairs for a few years, the only thing I would suggest is never use the old jack, if the centre pin is loose Using a multitester, check the continuity of each line. DC Power jack.
It's possible that you can fix the laptop by replacing the fuse. It's weird (for me) to have to reboot a system to enable a certain port when almost everything else is hotplug-able. I'd try searching the Dell site for a pinout or contact their tech support.RelatedDell E1505 Bluetooth Upgrade by bjepsonRemoving the battery of a Dell inspiron 3147. JulieAnn March 13, 2008 | You are an absolutely fantastic human being!
Thank you thank you THANK YOU! his comment is here Is there software that will let the computer run without a windows enviroment? Yet I can't find anything else to unscrew to loosen that area. I have two of these laptops so I tested the cpu, hardrive, in the good laptop and they worked fine.
Before you continue, be aware that GPRS use costs money. Thank you. Please let me know some ways to PERMENETLY fix my problem. http://transcoderesearch.com/dell-laptop/how-to-turn-on-dell-laptop-without-power-button.html I actually received a Toshiba Sattelite as a "hey if you can fix it it's yours" type deal.
You may NOT copy or distribute the content that appears on this site without written permission from Fixya Ltd. © 2005-2015, Fixya, Ltd. I am going to find some new plug replacements and try again though, waiting for the mail man so to speak. when i'm finishe i plugged the AC to my DC and get this burning noise coming from the DC then it started to smell like sometings burning.
cj2600 June 6, 2008 | headborg, Sorry, cannot help you with that one. and gpsd likes to close the serial device when no application is using it. The power jack terminals will look dirty because of melted flux. Let's ask: # hcitool info 00:0E:6D:1E:14:96 Requesting information ...
How long is it going to last? We checked the adapter and it's sending 12 volts fine. Must be a world first. navigate here LXIH-3 Built-in Dishwasher 2 Answers P1 error code on LX30 Hobart ...WILL BE 120 VOLTS PRESENT AT THE SUMP HEATER (yellow wires) DUE TO ONLY ONE LEG OF POWER BEING SWITCHED
I think so. the laptop is still dead. Plan to pay $75-175. Headborg, check out Fry's.
Using a toothpick, I worked a little more epoxy around the front edge, and not the whole thing is set up like a rock! Now melt the solder with the soldering gun and remove it with the pump. CB January 1, 2009 | Laptop repair guy do you have a degree in engineering or something cause the content on this site is excellent !!! ttyS15 at 0xd400 (irq = 11) is a PCTel PCI: Found IRQ 11 for device 00:1f.6 PCI: Sharing IRQ 11 with 00:1f.5 PCI: Sharing IRQ 11 with 02:03.0 PCTel initialization.
Module dependencies weirdness fixed Update: I fixed this for good (at least until I start using a different kernel) by using the orinoco standalone drivers from http://ozlabs.org/people/dgibson/dldwd/orinoco-0.13e.tar.gz and patching them with I hope you understand what I'm talking about. Plugged it up, worked great, charged with no problem. Looks like a 5.5mm barrel.
Order: 1 piece Miss Xiao Mo 1 PC Notebook Computer Replacement Cpu Cooling Radiator Fan for DELL C600 Series Laptops Cpu Cooler Fan S0I14 P18 0.1 US $1.76 / piece Min. Toshiba Satellite A75-s206 cj2600 March 16, 2008 | Randy, Why did you replace the power jack in the first place? Only if you practice.