Too weird, but it worked. Test the device Swap the device with a comparable device that works properly. Ensure that Windows recognizes the drive Click the Start button and click My Computer. Click Start. this contact form
Then press the power button again to turn on the computer. Thanks for sharing this gctech December 7, 2007 at 12:02 pm Reply CHECK FOR LEAKY CAPACITORS!! doris December 10, 2007 at 8:50 am Reply My orange blinking light is Check the diagnostic lights See "Diagnostic Lights." Check the card setting Enter system setup and ensure that Primary Video Controller under the Integrated Devices option is set correctly. It is a Dell desktop.
M5A99FX PRO R2 Wont start or even POST solved 2 sticks of RAM won't boot (2nd time because I accidentally selected a best answer even though my problem wasn't solved) solved Click the COM port for your modem. If you figure out that the problem lies on the hard drive or motherboard, then you need to diagnose the issue by manually removing the case and find out where the
Afterward, plug the computer in and turn it on. 5.-Reseat the ATX 20-pin connection and the 12V 4-pin (2 black and 2 yellow or 2 black and 2 brown) connection from Maybe the guys at Dell saved too much cost on this part. No boot sector on hard-disk drive The computer configuration information in system setup might be incorrect. Oct 23, 2008 #16 tb421ny TS Rookie Fix Optiplex machines Almost every Optiplex SX280 problem I have seen ( we have around 1000 at my job ) has been bad capacitors.
How long ago was that? First time I took off the cover and watched the inside (motherboard, etc). NOTE: If you have a video card installed, connector the monitor to the connector on the card. http://en.community.dell.com/support-forums/desktop/f/3514/t/17810114 For a PCI card, set Primary Video Controller to Auto.
Then enter system setup and go to the Integrated Devices option settings. The booting problem can be resolved by the following instructions discussed below. The computer started working. Test the video extension cable (if used) If you are using a video extension cable and removing the cable solves the problem, the cable is defective.
Apparently, one of my kittens must have ran behind my computer and jumped or something and knocked the connections loose. Homepage She decided to put a PCI wireless network card in it and since then it has reverted back to not working again. if your plug goes from the wall to the computer you do not have a surge protector and i would recommend getting one. John Lamansky January 1, 2008 at 9:30 please help...
Turn off call waiting (catch-phone) See your telephone directory for instructions on deactivating this feature. weblink I really like my Dell, but am annoyed that they do not have a manual with "trouble shooting". Errors occur and programs crash for no apparent reason. Select the disable code from the drop-down menu (for example, *70).
Check the mouse cable Check the cable connector for bent or broken pins and for damaged or frayed cables. Memory parity errors occur on parity-enabled computers. With ‘cold start' the power supply was not healtly anymore. navigate here Swearing under my breath.
I used my ‘puter to check my local movie times, went to see the movie, and came back with the blinking light. the only thing i can find that changes anything at all is leaving the cpu power disconnected and booting it. I went thru lots of headache trying to get my Dimension desktop fixed. 2 repair tech was going to charge me $250 to replace the MB; the other to replace I/O
Keep trying things one at a time until the problem goes away. Tony Spicuzza January 8, 2009 at 5:25 am Reply Here are some Dell pages on the issue: http://en.community.dell.com/forums/p/19245715/19384549.aspx Reconnect the power cord, and then turn on the computer. The operating system might have been corrupted. Ensure that the mouse cable is connected to the green connector on the back panel.
Straighten bent pins. Troubleshooting Dell 321 Comments Margo July 7, 2006 at 1:38 pm Reply John, You make a good point with the simple-fix method for your Dell Dimension. Some of these have already been mentioned above but I hope this prevents the frustration of scrolling the whole thread. HW Lelienhof September 12, 2008 at 5:55 am Reply Blinking his comment is here This happens WHILE I'M WORKING on stuff.
Place the "defect" PS into machine and the same problem was there. If any cables appear loose, reconnect them. Fixed pins and my P.C. Really hoping I don't have to go out and buy an new computer tomorrow.
General hardware problems If your computer exhibits one or more of the following symptoms, a device conflict may exist: Your computer locks up, particularly while using a specific device. When I swapped power supplies with a 2nd Dell Gx270 the 1st one started and loaded just fine. Click End Task. Which is practically the same machine in parts and performance, but one gets support in English if you pick the right option, and the other gets "May I know the status
Very frustrating -- and I've bought a lot of Dells and never had a problem before Dave January 17, 2008 at 8:59 am Reply I just had similar on 650 Search Items on Windows 8 from Start Screen Itself Advertisement No comments yet. I contacted our Small Business account Manager and reported that Support was not doing anything about Out of Warranty computers, and we had a bunch. Mouse Problems Fill out the Diagnostics Checklist as you complete these checks.